Two needed per baseboard joint. Price is for one item.
A well finished item, all faces are fully machined.
The most accurate way to align baseboards. Fixing screws included.
These dowels can also be used as plain
bearings for fiddle yard turntables & sector
plates. Providing a very compact pivot while
allowing the turntable deck to be lifted off. See
our Turntable Rollers for additional deck
support.
Fitting Notes
These dowels require a 9mm hole for the female
half, with both halves counter bored to 25mm
diameter x 3mm deep on the outside face. The
matching pair of baseboard ends should first be
clamped together & pilot drilled right through at
about 3mm. The two ends should then be
separated & counter bored with a 25mm spade
bit, finally open out the female half to 9mm.
