|
|
|
NOTE. Drawing also shows two rollers, these are shown for illustrative purposes only & not included with the bearing. Rollers are available separately.
Turntable or Sector Plate Bearing
A zinc plated steel ballraced thrust bearing with a 50kg capacity. 57mm square by 11mm deep.
Four 6mm screw holes on each face, located at a PCD of 60mm (forming a 43mm square).
This item cannot be dismantled so must be built into a removable base if a 'lift off' turntable is required, or see my other listings for the turntable spider.
For supporting the outboard edges of turntables or sector plates see rollers (FTB003).
This turntable bearing is intended for use in the fiddleyard area, rather than the scenic areas of the model railway baseboard.
|
|
|