Two needed per baseboard joint.
Price is for one item.
A well finished item, all faces are fully machined. The most accurate way to align baseboards.
These dowels can also be used as plain bearings for model railway fiddle yard turntables & sector plates. Providing a very compact pivot while allowing the turntable deck to be lifted off. See our Turntable Rollers for additional deck support. Fixing screws included.
These dowels require a 9mm hole for the female half, with both halves counter bored to 25mm diameter x 3mm deep on the outside face. The matching pair of baseboard ends should first be clamped together & pilot drilled right through at about 3mm. The two ends should then be separated & counter bored with a 25mm spade bit, finally open out the female half to 9mm.